Numerical study of a dense gas-solid jet flowFAN, J. R; SUN, P; CEN, K. F et al.Energy (Oxford). 1998, Vol 23, Num 10, pp 823-833, issn 0360-5442Article

Antierosion in a 90° bend by particle impactionFAN, J. R; YAO, J; CEN, K. F et al.AIChE journal. 2002, Vol 48, Num 7, pp 1401-1412, issn 0001-1541Article

Analysis of volatile species kinetics during typical medical waste materials pyrolysis using a distributed activation energy modelYAN, J. H; ZHU, H. M; JIANG, X. G et al.Journal of hazardous materials (Print). 2009, Vol 162, Num 2-3, pp 646-651, issn 0304-3894, 6 p.Article

Degradation of PCDD/Fs by mechanochemical treatment of fly ash from medical waste incinerationYAN, J. H; PENG, Z; LU, S. Y et al.Journal of hazardous materials. 2007, Vol 147, Num 1-2, pp 652-657, issn 0304-3894, 6 p.Article

Investigation of combustion enhancement by ozone additive in CH_4/air flames using direct laminar burning velocity measurements and kinetic simulationsWANG, Z. H; YANG, L; LI, B et al.Combustion and flame. 2012, Vol 159, Num 1, pp 120-129, issn 0010-2180, 10 p.Article

Inverse radiation analysis of simultaneous estimation of temperature field and radiative properties in a two-dimensional participating mediumLIU, D; YAN, J. H; WANG, F et al.International journal of heat and mass transfer. 2010, Vol 53, Num 21-22, pp 4474-4481, issn 0017-9310, 8 p.Article

Degradation of gas-liquid gliding arc discharge on Acid Orange IIYAN, J. H; LIU, Y. N; BO, Zh et al.Journal of hazardous materials. 2008, Vol 157, Num 2-3, pp 441-447, issn 0304-3894, 7 p.Article

Study on pyrolysis of typical medical waste materials by using TG-FTIR analysisZHU, H. M; YAN, J. H; JIANG, X. G et al.Journal of hazardous materials. 2008, Vol 153, Num 1-2, pp 670-676, issn 0304-3894, 7 p.Article

Modeling of NO_X emissions from a W-shaped boiler furnace under different operating conditionsFAN, J. R; LIANG, X. H; CHEN, L. H et al.Energy (Oxford). 1998, Vol 23, Num 12, pp 1051-1055, issn 0360-5442Article

Staged desulphurization by direct sorbent injection in pulverized-coal boilersMAKARYTCHEV, S. V; CEN, K. F; LUO, Z. Y et al.Energy (Oxford). 1994, Vol 19, Num 9, pp 947-956, issn 0360-5442Article

Investigation of flue-gas treatment with O₃ injection using NO and NO₂ planar laser-induced fluorescenceWANG, Z. H; LI, B; EHN, A et al.Fuel (Guildford). 2010, Vol 89, Num 9, pp 2346-2352, issn 0016-2361, 7 p.Article

Characteristic of polychlorinated dibenzo-p-dioxins and dibenzofurans in fly ash from incinerators in chinaCHEN, T; YAN, J. H; LU, S. Y et al.Journal of hazardous materials. 2008, Vol 150, Num 3, pp 510-514, issn 0304-3894, 5 p.Article

PCDD/F concentrations of agricultural soil in the vicinity of fluidized bed incinerators of co-firing MSW with coal in Hangzhou, ChinaYAN, J. H; XU, M. X; LU, S. Y et al.Journal of hazardous materials. 2008, Vol 151, Num 2-3, pp 522-530, issn 0304-3894, 9 p.Article

Large eddy simulation of inhaled particle deposition within the human upper respiratory tractJIN, H. H; FAN, J. R; ZENG, M. J et al.Journal of aerosol science. 2007, Vol 38, Num 3, pp 257-268, issn 0021-8502, 12 p.Article

A numerical model for dense particle-laden jetsFAN, J. R; JIN, J; ZHANG, X. Y et al.Powder technology. 2001, Vol 115, Num 3, pp 256-264, issn 0032-5910Article

Simulation of ash deposit in a pulverized coal-fired boilerFAN, J. R; ZHA, X. D; SUN, P et al.Fuel (Guildford). 2001, Vol 80, Num 5, pp 645-654, issn 0016-2361Article

Numerical and experimental investigation on the reduction of NO_x emission in a 600 MW utility furnace by using OFAFAN, J. R; SUN, P; ZHENG, Y. Q et al.Fuel (Guildford). 1999, Vol 78, Num 12, pp 1387-1394, issn 0016-2361Article

Development of Catalyst-Sorbents for Simultaneous Removal of SO₂ From Flue Gas by Low Temperature Ozone OxidationWANG, Z. H; ZHANG, X; ZHU, Y. Q et al.Ozone : science & engineering. 2012, Vol 34, Num 3, pp 204-212, issn 0191-9512, 9 p.Article

Simultaneous Measurement of Three-Dimensional Soot Temperature and Volume Fraction Fields in Axisymmetric or Asymmetric Small Unconfined Flames With CCD CamerasLIU, D; HUANG, Q. X; WANG, F et al.Journal of heat transfer. 2010, Vol 132, Num 6, issn 0022-1481, 061202.1-061202.7Article

Particle field characterization by digital in-line holography : 3D location and sizingPU, S. L; ALLANO, D; PATTE-ROULAND, B et al.Experiments in fluids. 2005, Vol 39, Num 1, pp 1-9, issn 0723-4864, 9 p.Article

A two-dimensional mathematical model of liquid-feed direct methanol fuel cellsFAN, J. R; HU, G. L; YAO, J et al.Energy & fuels. 2002, Vol 16, Num 6, pp 1591-1598, issn 0887-0624, 8 p.Article

Experimental studies on municipal solid waste pyrolysis in a laboratory-scale rotary kilnLI, A. M; LI, X. D; LI, S. Q et al.Energy (Oxford). 1999, Vol 24, Num 3, pp 209-218, issn 0360-5442Article

Turbulent fluid and particle interaction in the boundary layer for cross flow over a tubeFAN, J. R; ZHANG, X. Y; JIN, J et al.International journal of multiphase flow. 1998, Vol 24, Num 2, pp 213-223, issn 0301-9322Article

Modeling of coal combustion and NO_x formation in a W-shaped boiler furnaceFAN, J. R; JIN, J; LIANG, X. H et al.Chemical engineering journal (1996). 1998, Vol 71, Num 3, pp 233-242, issn 1385-8947Article

Axial transport and residence time of MSW in rotary kilns. Part I. ExperimentalLI, S.-Q; YAN, J.-H; LI, R.-D et al.Powder technology. 2002, Vol 126, Num 3, pp 217-227, issn 0032-5910, 11 p.Article