Fuel Effect on Particulate Matter Composition and Soot Oxidation in a Direct-Injection Spark Ignition (DISI) EngineCHONGMING WANG; HONGMING XU; HERREROS, Jose Martin et al.Energy & fuels. 2014, Vol 28, Num 3-4, pp 2003-2012, issn 0887-0624, 10 p.Article

Effect of mixture strength and injection timing on combustion characteristics of a direct injection hydrogen-fueled engineHAMADA, Khalaf I; RAHMAN, M. M; ABDULLAH, M. A et al.International journal of hydrogen energy. 2013, Vol 38, Num 9, pp 3793-3801, issn 0360-3199, 9 p.Article

Time-averaged heat transfer correlation for direct injection hydrogen fueled engineHAMADA, Khalaf I; RAHMAN, M. M; AZIZ, A. Rashid A et al.International journal of hydrogen energy. 2012, Vol 37, Num 24, pp 19146-19157, issn 0360-3199, 12 p.Article

Development of a Real-Time NO_x Prediction Model Based on Heat Release Analysis in a Direct-Injection Diesel EngineDONG WANG; CHAO ZHANG.Journal of engineering for gas turbines and power. 2014, Vol 136, Num 3, issn 0742-4795, 034501.1-034501.4Article

Parametric study of instantaneous heat transfer based on multidimensional model in direct-injection hydrogen-fueled engineHAMADA, Khalaf I; RAHMAN, M. M; AZIZ, A. Rashid A et al.International journal of hydrogen energy. 2013, Vol 38, Num 28, pp 12465-12480, issn 0360-3199, 16 p.Article

Towards total-consumption pneumatic liquid micro-sample-introduction systems in ICP spectrochemistry : Trends 2004MERMET, Jean-Michel; TODOLI, José-Luis.Analytical and bioanalytical chemistry. 2004, Vol 378, Num 1, pp 57-59, 3 p.Article

Experimental and numerical investigation on the jet characteristics of spark ignition direct injection gaseous injectorCHITSAZ, Iman; MOHAMMAD HASSAN SAIDI; ALI ASGHAR MOZAFARI et al.Applied energy. 2013, Vol 105, pp 8-16, issn 0306-2619, 9 p.Article

Gaseous and particulate matter emissions of biofuel blends in dual-injection compared to direct-injection and port injectionDANIEL, Ritchie; HONGMINGXU; CHONGMING WANG et al.Applied energy. 2013, Vol 105, pp 252-261, issn 0306-2619, 10 p.Article

Assessing the cleanability of a direct nozzle injection systemDOERPMUND, Malte; CAI, Xiang; WALGENBACH, Martin et al.Biosystems engineering. 2011, Vol 110, Num 1, pp 49-56, issn 1537-5110, 8 p.Article

Development and validation of a comprehensive two-zone model for combustion and emissions formation in a DI diesel engineRAKOPOULOS, C. D; RAKOPOULOS, D. C; KYRITSIS, D. C et al.International journal of energy research. 2003, Vol 27, Num 14, pp 1221-1249, issn 0363-907X, 29 p.Article

Modeling study of soot formation and oxidation in DI diesel engine using an improved soot modelXIAOBEI CHENG; LIANG CHEN; GUANG HONG et al.Applied thermal engineering. 2014, Vol 62, Num 2, pp 303-312, issn 1359-4311, 10 p.Article

Optical characterization of combustion processes in a DISI engine equipped with plasma-assisted ignition systemMEROLA, Simona Silvia; MARCHITTO, Luca; TORNATORE, Cinzia et al.Applied thermal engineering. 2014, Vol 69, Num 1-2, pp 177-187, issn 1359-4311, 11 p.Article

Methodology for Estimating the Performance of Fuels during Cold Start and Idle with the Adaptation of a Gradation SystemPIPEREL, A; PERRIN, H; WALTER, B et al.Energy & fuels. 2013, Vol 27, Num MARAVR, pp 1625-1631, issn 0887-0624, 7 p.Article

Influence of biodiesel fuel on the combustion and emission formation in a direct injection (DI) diesel engineHRIBERNIK, Ales; KEGL, Breda.Energy & fuels. 2007, Vol 21, Num 3, pp 1760-1767, issn 0887-0624, 8 p.Article

An experimental study of negative valve overlap injection effects and their impact on combustion in a gasoline HCCI engineHUNICZ, Jacek.Fuel (Guildford). 2014, Vol 117, pp 236-250, issn 0016-2361, 15 p., aArticle

Improving gasoline direct injection (GDI) engine efficiency and emissions with hydrogen from exhaust gas fuel reformingFENNELL, Daniel; HERREROS, Jose; TSOLAKIS, Athanasios et al.International journal of hydrogen energy. 2014, Vol 39, Num 10, pp 5153-5162, issn 0360-3199, 10 p.Article

Investigation on combustion performance and emission characteristics of a DI (direct injection) diesel engine fueled with biogas-diesel in dual fuel modeBARIK, Debabrata; MURUGAN, S.Energy (Oxford). 2014, Vol 72, pp 760-771, issn 0360-5442, 12 p.Article

The Miller cycle effects on improvement of fuel economy in a highly boosted, high compression ratio, direct-injection gasoline engine: EIVC vs. LIVCTIE LI; YI GAO; JIASHENG WANG et al.Energy conversion and management. 2014, Vol 79, pp 59-65, issn 0196-8904, 7 p.Article

Fueling a stationary direct injection diesel engine with diesel-used palm oil―butanol blends ― An experimental studySHARON, H; JAI SHIVA RAM, P; JENIS FERNANDO, K et al.Energy conversion and management. 2013, Vol 73, pp 95-105, issn 0196-8904, 11 p.Article

Effect of nano air-bubbles mixed into gas oil on common-rail diesel engineNAKATAKE, Yasuhito; KISU, Shintaro; SHIGYO, Kenta et al.Energy (Oxford). 2013, Vol 59, pp 233-239, issn 0360-5442, 7 p.Article

Experimental evaluation of local instantaneous heat transfer characteristics in the combustion chamber of air-cooled direct injection diesel engineRAKOPOULOS, C. D; MAVROPOULOS, G. C.Energy (Oxford). 2008, Vol 33, Num 7, pp 1084-1099, issn 0360-5442, 16 p.Article

Applications of the LIF method for the diagnostics of the combustion process of gas-IC-enginesKIRCHWEGER, Wolfram; HASLACHER, Rainer; HALLMANNSEGGER, Michael et al.Experiments in fluids. 2007, Vol 43, Num 2-3, pp 329-340, issn 0723-4864, 12 p.Conference Paper

Einige Aspekte bezüglich Gemischbildung und Verbrennung im Rahmen des Direktstarts von Ottomotoren mit Benzin-Direkteinspritzung = Considerations about mixture preparation and combustion concerning the Direct Start of Gasoline Direct Injection enginesKULZER, A; ZÜLCH, C; MÖSSNER, D et al.VDI-Berichte. 2003, pp 29-40, issn 0083-5560, isbn 3-18-091808-X, 12 p.Conference Paper

Effects of injection pressure on the structural transformation of flash-boiling sprays of gasoline and ethanol in a spark-ignition direct-injection (SIDI) engineCHAN, Qing N; YONGMING BAO; SANGHOON KOOK et al.Fuel (Guildford). 2014, Vol 130, pp 228-240, issn 0016-2361, 13 p.Article

Effects of shape and surface roughness on icing and condensation characteristics of an injector in a liquid phase LPG injection systemTAE YOUNG KIM; YONGGYU LEE; CHANGUP KIM et al.Fuel (Guildford). 2014, Vol 132, pp 82-92, issn 0016-2361, 11 p.Article