Experimental analysis of R22 and R407c flow through electronic expansion valveZHANG CHUAN; MA SHANWEI; CHEN JIANGPIN et al.Energy conversion and management. 2006, Vol 47, Num 5, pp 529-544, issn 0196-8904, 16 p.Article

A generalized correlation for refrigerant mass flow rate through adiabatic capillary tubesCHOI, Jongmin; KIM, Yongchan; HO YOUNG KIM et al.International journal of refrigeration. 2003, Vol 26, Num 8, pp 881-888, issn 0140-7007, 8 p.Article

The influence of two-phase flow on a Coriolis effect mass flow meter. DiscussionHAWKEN, P. J; HEARTY, P. F; LEMAL, C et al.ASHRAE transactions. 1985, Vol 91, Num 1, pp 310-321, issn 0001-2505Article

Influence of lateral confinement on dynamic damage evolution during uniaxial compressive response of brittle solidsCHENGYI HUANG; SUBHASH, Ghatu.Journal of the mechanics and physics of solids. 2003, Vol 51, Num 6, pp 1089-1105, issn 0022-5096, 17 p.Article

The Hall-Petch breakdown in nanocrystalline metals : A crossover to glass-like deformationTRELEWICZ, Jason R; SCHUH, Christopher A.Acta materialia. 2007, Vol 55, Num 17, pp 5948-5958, issn 1359-6454, 11 p.Article

Ball indentation tests for a Zr-based bulk metallic glassTRICHY, G. R; SCATTERGOOD, R. O; KOCH, C. C et al.Scripta materialia. 2005, Vol 53, Num 12, pp 1461-1465, issn 1359-6462, 5 p.Article

Condensation performance in horizontal tubes with second-law considerationLIN, W. W; LEE, D. J; PENG, X. F et al.International journal of energy research. 2001, Vol 25, Num 11, pp 1005-1018, issn 0363-907XArticle

Effect of refrigerant flow control on the thermodynamic performances of reciprocating chillersTASSOU, S. A; AL-NIZARI, H. O.Applied energy. 1993, Vol 45, Num 2, pp 101-116, issn 0306-2619Article

A comparison of critical flow models for estimating two-phase flow of HCFC22 and HFC134a through short tube orificesKIM, Y; O'NEAL, D. L.International journal of refrigeration. 1995, Vol 18, Num 7, pp 447-455, issn 0140-7007Article

Thermodynamic analysis of R22―DMF compression―absorption heat pumpGEORGE, J. M; MARZ, W; SRINIVASA MURTHY, S et al.Heat recovery systems & CHP. 1989, Vol 9, Num 5, pp 433-446, issn 0890-4332Article

Irreversibility analysis of a water-to-water mechanical-compression heat pumpHONGMEI LIANG; KUEHN, T. H.Energy (Oxford). 1991, Vol 16, Num 6, pp 883-896, issn 0360-5442, 14 p.Article

On the criterion for compensation to avoid elastic―plastic transients during strain rate change testsMANIK, T; HOLMEDAL, B.Acta materialia. 2013, Vol 61, Num 2, pp 653-659, issn 1359-6454, 7 p.Article

IL-22 : A critical mediator in mucosal host defenseAUJLA, S. J; KOLLS, J. K.Journal of molecular medicine (Berlin. Print). 2009, Vol 87, Num 5, pp 451-454, issn 0946-2716, 4 p.Article

Activation volume and strain rate sensitivity in plastic deformation of nanocrystalline TiWANG, F; LI, B; GAO, T. T et al.Surface & coatings technology. 2013, Vol 228, issn 0257-8972, S254-S256, SUP1Conference Paper

Strain hardening, strain rate sensitivity, and ductility of nanostructured metalsWANG, Y. M; MA, E.Materials science & engineering. A, Structural materials : properties, microstructure and processing. 2004, Vol 375-77, pp 46-52, issn 0921-5093, 7 p.Conference Paper

Comparisons between homogeneous boundaries and heterophase interfaces in plastic deformation: Nanostructured Cu micropillars vs. nanolayered Cu-based micropillarsZHANG, J. Y; LIU, G; SUN, J et al.Acta materialia. 2013, Vol 61, Num 18, pp 6868-6881, issn 1359-6454, 14 p.Article

Mechanical properties of nanocrystalline nickel films deposited by pulse platingSHEN, Y. F; XUE, W. Y; WANG, Y. D et al.Surface & coatings technology. 2008, Vol 202, Num 21, pp 5140-5145, issn 0257-8972, 6 p.Article

Shear striations and deformation kinetics in highly deformed Zr-based bulk metallic glassesDALLA TORRE, Florian H; DUBACH, Alban; SCHÄLLIBAUM, Justus et al.Acta materialia. 2008, Vol 56, Num 17, pp 4635-4646, issn 1359-6454, 12 p.Article

Hardness and strain rate sensitivity of nanocrystalline CuCHEN, J; LU, L; LU, K et al.Scripta materialia. 2006, Vol 54, Num 11, pp 1913-1918, issn 1359-6462, 6 p.Article

Temperature and strain rate effects in cold spray investigated by smoothed particle hydrodynamicsLEMIALE, V; KING, P. C; RUDMAN, M et al.Surface & coatings technology. 2014, Vol 254, pp 121-130, issn 0257-8972, 10 p.Article

Size-dependent deformation mechanisms and strain-rate sensitivity in nanostructured Cu/X (X = Cr, Zr) multilayer filmsNIU, J. J; ZHANG, J. Y; LIU, G et al.Acta materialia. 2012, Vol 60, Num 9, pp 3677-3689, issn 1359-6454, 13 p.Article

Anomalies in Hall-Petch strengthening for nanocrystalline Au―Cu alloys below 10 nm grain sizeJANKOWSKI, Alan F; NYAKITI, Luke O.Surface & coatings technology. 2010, Vol 205, Num 5, pp 1398-1402, issn 0257-8972, 5 p.Conference Paper

The mechanical strength of submicron porous silver foilsTANVIR AHMED, H. S; JANKOWSKI, Alan F.Surface & coatings technology. 2009, Vol 204, Num 6-7, pp 1026-1029, issn 0257-8972, 4 p.Conference Paper

Strain rate sensitivity and Hall-Petch behavior of ultrafine-grained gold wiresCHEW, Y. H; WONG, C. C; WUIFF, F et al.Thin solid films. 2008, Vol 516, Num 16, pp 5376-5380, issn 0040-6090, 5 p.Conference Paper

A comment on the role of Frank-Read sources in plasticity of nanomaterialsESTRIN, Y; KIM, H. S; NABARRO, F. R. N et al.Acta materialia. 2007, Vol 55, Num 19, pp 6401-6407, issn 1359-6454, 7 p.Article